Silhouette Cameo®

About the Silhouette Cameo®
The Silhouette Cameo® is a roll-through desktop cutting machine. The Cameo comes in 12-inch, 15-inch (Plus), and 24-inch (Pro) width options. The Cameo all...
Tue, 10 Jan, 2023 at 11:29 AM
Loading the Cameo
The following videos provide a walkthrough on how to properly load your Cameo machine. Cameo Cameo Plus Cameo Pro
Wed, 7 Sep, 2022 at 1:20 PM
Cameo Machine Measurements
Cameo 4 measurements are as follows: Width: 22.5 inches Height: 6.7 inches Depth: 7.7 inches  NOTE: Allow 14 inch clearance in front and back to accommo...
Mon, 19 Sep, 2022 at 4:43 PM
Cameo 4 Loading Sensor Issue
The Cameo 4 Loading Sensor allows the machine to detect when materials are being loaded. It is the small hole located in front of the left-hand roller: ...
Sat, 26 Nov, 2022 at 11:17 AM
Cameo 4 Loading Arrow Flashing
About the Auto-Loading Feature The Cameo 4 includes an auto-loading feature. When the loading arrow on the Cameo 4 model is flashing, this indicates that t...
Tue, 10 Jan, 2023 at 9:04 AM
Cameo Carriage Moves to Wrong Position on Startup
Upon startup, the Cameo's blade carriage will orient itself into a starting position. When performed properly, the startup process is very fast. How...
Fri, 27 Jan, 2023 at 9:06 AM
Left-Hand Roller Bar Not Lifting Up
Some newer Cameo owners may assume that the roller bar is intended to be lifted in order to load material, so that you can push materials into place and the...
Tue, 18 Oct, 2022 at 4:59 PM
Can't Set Full Cutting Area for Cameo Pro
If you are unable to set your page size to pre-set options for the Cameo Pro model under the Page Settings panel, this indicates you are likely running an o...
Wed, 7 Dec, 2022 at 1:14 PM
High Pitch Noise from Cameo 4
If you are hearing a high-pitch noise being emitted from your Cameo 4 model, please rest assured that the sound you are hearing does not indicate a defect w...
Fri, 3 Feb, 2023 at 12:54 PM
About the Cameo 5
Information on the new Cameo 5 model can be found at the following link: If you have not already done so, we wo...
Wed, 13 Sep, 2023 at 4:08 PM